Newer
Older
[PACKAGE]: ../../raw/master/mkp/cisco_fw_nat_translations-0.0.2-20230607.mkp "cisco_fw_nat_translations-0.0.2-20230607.mkp"
**Note**: before you update to a newer version, always check the [CHANGELOG](CHANGELOG). There might be incompatible changes.
---
### Installation
You can install the package by uploading it to your CheckMK site and as site user run
```
mkp install PACKAGENAME-VERSION.mkp
```
or beginning with CMK2.2.x
```
mkp add PACKAGENAME-VERSION.mkp
mkp enable PACKAGENAME VERSION
```
In the non RAW editions of CheckMK you can use the GUI to install the package (_Setup_ -> _Extension Packages_ -> _Upload package_)
Nice ;-) Have a look at the [contribution guidelines](CONTRIBUTING.md "Contributing")
---
### Check Info
The plugin creates the service **_Config change_**.
<details><summary>Montoring states</summary>
| State | condition | WATO |
| ----- | --------- | ---- |
| WARN/CRIT | if active NAT translations is outside of configured levels | yes |
| Metric | Unit | Perfometer |
| ------ | ------ | ------ |
| Active | count | yes |
| Peak | count | not |
</details>
---
### WATO
<details><summary>Service monitoring rule</summary>
| Section | Rule name |
| ------ | ------ |
| NAT translations | none |
| NAT translations lower levels | none |
**Note:** you can configure _NAT translations_ for predictive monitoring. In this case _NAT translations lower levels_ will not be used.
</details>
<details><summary>Discovery rule</summary>
There is no discovery rule
</details>
---
### Sample Output
Sample output
